Hydor H2 Show Volcano Kit
The Hydro H2 Show Volcano Kit is perfect for aquariums up to 52 gallons in size. It features a hand painted resin ornament, bubble maker and a red LED spotlight that virtually hides all equipment. This kit creates stunning effects in your aquarium with red bubbles flowing from the top of the ornament, giving you the illusion of an erupting volcano. The red LED light goes inside the volcano, which has small, see-through slits in it that are waterproof. The slits allow the red LED light to shine through, giving the effect that the volcano is full of lava. The bubbles only come out of the top as the volcano erupts into thousands of strong, even bubbles. The bubbles oxygenate the tank wonderfully and energize the fish.
Features a hand-painted ornament that hides equipment
Gives the illusion of an erupting volcano
Suitable for both fresh and marine water
Low energy consumption
Easy and simple to install
Unwind the electrical cord and the air intake tube.
Connect the air intake tube to the air pump chamber.
Position the air pump in the aquarium. For perfect stability, cover the base with gravel. In order to prevent noise and disturbance caused by vibrations, position the pump so it does not come in contact with the aquarium wall or other objects.
Fix the electrical cord, joined to the air intake tube, to the aquarium base and side using the supplied suction cups.
Cut the air intake tube so that it extends at least 1-1/2" from the aquarium frame and then insert air control valve.
Plug the Hydor Bubble Maker into the electrical supply.
NOTE: Verify that all components of the air pump are undamaged. Always operate the air pump underwater. Running the pump dry will cause structural damage to the rotor. Install the product at the suggested depth to prevent accidental damage or limited functioning.
Regular cleaning and maintenance of the air pump will ensure better performance and durability. Before any kind of maintenance, always disconnect the air pump.
Detach the light assembly and gently wipe the protective cover.
Separate the Channeled Bubble Maker Casing from the Bubble Maker body and remove the rotor.
Clean the rotor of lime scale with a soft, nonmetallic brush.
Rinse thoroughly with lukewarm water and re-assemble components. Make sure the rotor is properly positioned in place.
Do not use solvents or detergents.
5" L x 5" W x 4.5" H